We clear stubborn, recurring, and grease-clogged drain and sewer lines with high-pressure hydro jetting, scouring the full inside diameter of the pipe rather than punching a single path through a clog.
If a cable snake has been run through your line before, cleared the immediate clog, and the same drain backed up again a few weeks later, that's the pattern hydro jetting is built to fix. A cable clears a path; it doesn't remove what's coating the pipe walls.
Most first-time, single-fixture clogs don't need jetting; a cable snake handles those efficiently and at lower cost. Jetting earns its cost when a line has real buildup along its length: grease accumulation in a kitchen line, scale in an older section of pipe, or light-to-moderate root intrusion at a joint. We confirm which situation you're in with a camera before recommending jetting over a simpler snaking job, so you're not paying for more than the problem needs.
For Queen Creek specifically, we see this most in kitchen lines with ongoing grease buildup and in main lines that have backed up more than once during monsoon season, where recurring pressure has pushed existing buildup further along the pipe each time.
Even in newer construction, PVC drain lines aren't immune to buildup: soap scum, mineral deposits from the same hard water that scales up water heaters, and everyday grease from cooking all accumulate on pipe walls over years regardless of how new the material is. Jetting resets that to essentially bare pipe. Lines that get jetted periodically tend to go years between any real drain trouble at all, instead of the every-few-months pattern a repeatedly snaked line often falls into. That's the real cost comparison worth making over the life of the plumbing, not just the price of one visit against another.
Recurring clog? Call (480) 741-9332 for a camera-verified assessment.
We start with a camera pass to confirm jetting is the right approach and to note any spots that need extra attention. The jetting hose then runs the length of the line, and the high-pressure nozzle scours the pipe walls as it's pulled back through. A second camera pass afterward confirms the line is actually clear, not just that water is flowing again, since flowing water can mask a partial blockage that will cause trouble again soon.
Most residential jobs finish in under two hours. Commercial grease line jobs, especially a line that's gone a long time between services, can take longer depending on how much buildup has accumulated. Any water pressure and equipment use follows standard industry safety practice for the pipe material involved, which is part of why we confirm material and condition with a camera before jetting anything.
Every range below is a real starting point; your exact price is written down and approved before we start.
If the camera shows structural damage rather than just buildup, see sewer line repair for what that involves. Want a real number for your line? Call (480) 741-9332.
Call now and we'll assess whether jetting is the right fix for your line.
A snake cable breaks through or hooks a single clog and pulls it out. Hydro jetting uses a high-pressure water stream to scour the entire inner diameter of the pipe, removing grease, scale, and debris buildup a cable simply pushes past.
We adjust the water pressure to the pipe material and condition. A camera inspection beforehand tells us if a line has damage that makes jetting unsafe, in which case we'd recommend a different approach rather than risk making it worse.
That's one of the clearest signs jetting is the better fix. Snaking clears a path through buildup; jetting removes the buildup itself, which is usually why the clog stops recurring.
It can cut through and clear light to moderate root intrusion effectively. For more severe intrusion that's actually cracked or displaced the pipe, jetting clears the immediate blockage but the underlying damage still needs a repair, which we'd assess with a camera.
Yes, including restaurant grease lines, which is one of the most common commercial hydro jetting calls we get.